Rev.: 20 708115
Platform: DBALL2
Firmware TL6:
© 201 Directed.7 All rights reserved.
23
14
Power Managment leftECU
ray 31-pin connector(g )
1
2
3
4
5
6
7
17 16 15 14 13 12 11 10 9 8
18
19
26
27
2021
22
28
29
23
24
25
30
31
(-) : iPTS Violet, p n 17
BRX:
pin 26Red,
BTX:
Blue, pin 25
(-) :Unlock
pin 24Gray,
(-) :Parking lights
pin 30White,
Diode 1A
Diode 1A
Diode 1A
(-) :Lock
pin 11Red,
Body ECU
(white 30-pin
onnector)c
Main
Body
ECU
(-) Release:Trunk pin 5Red,
Body ECU
(white 28-pin onnector)c
(-) Trunk Status Input
[1] ( ) T Status InputAC ach
(-) Door Status Input
(-) E-Brake Status Input
(-) Ground
(+) Brake Input
(-) Hood Status Input
HS CAN High: 3Tan/Black:
HS CAN Low: 4Tan:
(-) Ground: 12Brown :/Red
(-) Output:SLP 11Yellow :/Red
(+) 12V :Input 13Red:
(-) Ground: 14Black:
(+) Brake Output: Gray: 6
(-) Hood Status Output: 9Violet/Brown:
Immo Data 1: Yellow/Black: 10
(+) Ignition Status Output: Gray/Black: 7
Immo Data 2: Orange/Black: 11
(-) Push-to-Start Output: Green/Black: 2
(-) Door Status Output: Green/White: 3
(-) Trunk Status Output: Red/Black: 4
[1] ( ) Tach Output: 5AC Violet/White:
(-) Lock Output: Blue/Red: 12
(-) E-Brake : 1Status Black/White:
(+) Ignition Input/Output
Remote
Starter
(-) (Status)GWR
(+) Starter Output
(-) Parking Lights Output
8: (+) Starter InputViolet:
10: Blue/White:
(-) (Status) InputGWR
9: (+) Ignition InputPink:
(-) OutputLock
(-) OutputUnlock
(-) Trunk OutputRelease
Diagnostic Connector OBDII
(connector side view)
18
169
12
3
5
4
7
6
HS CAN High:
pin 6Blue,
HS CAN Low:
pin 14White,
(+) :12V
Blue,
pin 16
(-) SLP:
Pink, pin 4
(+) 12V Input
20
1
2
34
17
28
16
5
18 19
2223
109876
25 2724 2623
13 1512 1411
1
7
19
3
9
21
30
6
4
28
2625
8
20
2
10 12
22
24
11
13 15
27
181716
5
29
(+) 12V
Steering Lock
(black onnector)7-pin c
Page 9
Install Typeation 3
10
RF
Prog utton. B
LED
4
2
TX
(-) Ground
RX
(+)12V
P#: 2D65XKD
2DBALL
14
12
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the diagnostic connector.OBDII
[1] Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
Not required in D2D mode.
Autolight Interrupt (veh.side): 9Orange/Yellow:
Autolight Interrupt (conn.side): 8Yellow:
Fuse 7.5A
(-) lights:Auto
pinGreen, 28
Do not connect these wires:
accessory ignition starter,,
from the remote starter to the vehicle.
To Next Page
Loading...
Need help?
General
