EasyManuals Logo

Directed XpressKit User Manual

Directed XpressKit
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
Rev.: 20 708115
Platform: DBALL2
Firmware TL6:
© 201 Directed.7 All rights reserved.
Driver Door Module
Diagnostic Connector OBDII
(connector side view)
(-) :Unlock
pin 24Violet,
(-) Parking lights:
pin 30Black,
Diode 1A
Diode 1A
Diode 1A
12
34
56
16
15
14
13
12 11
10
9
87
171819
2021
22
23
24
(-) :Lock
Gray, pin 16
Push-to-Start
(black onnector)10-pin c
ENGINE
START
STOP
2345
109876
1
(-) :PTS
pin 1Green,
(-) Trunk Status Input
[1] ( ) T Status InputAC ach
(-) Door Status Input
(-) E-Brake Status Input
Remote
Starter
(-) (Status)GWR
(-) OutputLock
(+) Starter Output
(-) OutputUnlock
(-) Trunk OutputRelease
(-) Ground
(+) Brake Input
(-) Hood Status Input
(+) Ignition Input/Output
(-) E-Brake :Status
18
169
12
3
5
4
7
6
(+) :12V pin 16Yellow,
(-) SLP:
Blue, in 4P
(+) 12V Input
Driver Door
Module
24(white -pin
onnector)c
(+) 12V
Steering Lock
(black 7-pin
onnector)c
Page 7
Installation Type 2
10
RF
Prog utton. B
LED
4
14
12
2
P#: 2D65XKD
TX
(-) Ground
RX
(+)12V
2DBALL
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the diagnostic connector.OBDII
[1] Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
Not required in D2D mode.
Fuse 7.5A
BTX:
Black, pin 25
HS CAN High:
pin 14Pink or White,
BRX:
White or Green,
pin 26
1
7
19
3
9
21 30
6
4
28
2625
8
20
2
10 12
2223
24
11
1413 15
27
181716
5
29
()- Parking Lights Output
HS CAN High: 3Tan/Black:
HS CAN Low: 4Tan:
(-) Ground: 12Brown :/Red
(-) Output:SLP 11Yellow :/Red
(+) 12V :Input 13Red:
(-) Ground: 14Black:
(+) Brake Output: Gray: 6
(-) Hood Status Output: 9Violet/Brown:
Immo Data 1: Yellow/Black: 10
(+) Ignition Status Output: Gray/Black: 7
Immo Data 2: Orange/Black: 11
(-) Push-to-Start Output: Green/Black: 2
(-) Door Status Output: Green/White: 3
(-) Trunk Status Output: Red/Black: 4
[1] ( ) Tach Output: 5AC Violet/White:
(-) Lock Output: Blue/Red: 12
Black/White: 1
8: (+) Starter InputViolet:
10: Blue/White:
(-) (Status) InputGWR
9: (+) Ignition InputPink:
Autolight Interrupt (veh.side): 9Orange/Yellow:
Autolight Interrupt (conn.side): 8Yellow:
HS CAN Low:
Violet, pin 13
20
(-) ReleaseTrunk :
Yellow, pin 8
Body ECU
(white 28-pin onnector)c
1
2
34
17
28
16
5
Main
Body
ECU
8
18 19
2223
10976
25 2724 2623
13 1512 1411
Body ECU
(white -pin30
onnector)c
Do not connect these wires:
accessory ignition starter, , from
the remote starter to the vehicle.
(-) Autolight:
Red, pin 28

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Directed XpressKit and is the answer not in the manual?

Directed XpressKit Specifications

General IconGeneral
BrandDirected
ModelXpressKit
CategoryRemote Starter
LanguageEnglish

Related product manuals