Directed XpressKit User Manual

Rev.: 20 708115
Platform: DBALL2
Firmware TL6:
© 201 Directed.7 All rights reserved.
Solder onto a diode, cut away the unneeded
portion, and then insert into empty pin as shown.
Diodes
Solder the
wire to secure
it on the metal
pin.
This part can be removed because
only the metal pin is needed to
secure the contact in the empty pin.
Diagnostic Connector OBDII
(connector side view)
(+) :12V pin 16
(-) Trunk Status Input
[1] ( ) T Status InputAC ach
(-) Door Status Input
(-) E-Brake Status Input
(-) Ground
(+) Brake Input
(-) Hood Status Input
HS CAN High: 3Tan/Black:
HS CAN Low: 4Tan:
(-) Ground: 12Brown :/Red
(-) Output:SLP 11Yellow :/Red
(+) 12V :Input 13Red:
(-) Ground: 14Black:
(+) Brake Output: Gray: 6
(-) Hood Status Output: 9Violet/Brown:
Immo Data 1: Yellow/Black: 10
(+) Ignition Status Output: Gray/Black: 7
Immo Data 2: Orange/Black: 11
(-) Push-to-Start Output: Green/Black: 2
(-) Door Status Output: Green/White: 3
(-) Trunk Status Output: Red/Black: 4
[1] ( ) Tach Output: 5AC Violet/White:
(-) E-Brake : 1Status Black/White:
Steering Lock
(black or Blue
c7-pin onnector)
(+) Ignition Input/Output
Remote
Starter
(-) (Status)GWR
(-) OutputLock
(+) Starter Output
(-) OutputUnlock
(-) Trunk Output
1: (-) Lock InputGreen:
2: (-) Unlock InputBlue:
3: (-) Trunk InputRed/White:
8: (+) Starter InputViolet:
10: Blue/White:
(-) (Status) InputGWR
9: (+) Ignition InputPink:
ENGINE
START
STOP
Push-toStart
(black 10-pin
onnector)c
2345
109876
1
(-) PTS: pin 1
12
3
5
4
7
6
(-) :SLP
pin 4
(+) 12V Input(+) 12V
Page 16
Installation Type 6
10
RF
Prog utton. B
LED
4
2
P#: 2D65XKD
TX
(-) Ground
RX
(+)12V
2DBALL
14
12
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the diagnostic connector.OBDII
[1] Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
Not required in D2D mode.
Autolight Interrupt (veh.side): 9Orange/Yellow:
Autolight Interrupt (conn.side): 8Yellow:
Fuse 7.5A
18
169
BRX: pin 26 BTX: pin 25
(-) lights: pinAuto 28
8
9
7
20
21
19
5
6
17
18
16
29
4
27
15
11
12
10
23
24
22
28
3030
25
26
2
3
1
Body ECU
(white 30-pin
onnector)c
(-) Parking Lights Output
FUSE
BODY ECU
(-) Parking lights:
pin 30
Do not connect these wires:
accessory ignition starter,,
from the remote starter to the vehicle.
14
13
HS CAN High: pin 14
HS CAN Low: pin 13

Directed XpressKit Specifications

General

Brand	Directed
Model	XpressKit
Category	Remote Starter
Language	English