Directed XpressKit - Installation Guide - Type 7

Rev.: 20 708115
Platform: DBALL2
Firmware TL6:
© 201 Directed.7 All rights reserved.
Diagnostic Connector OBDII
(connector side view)
(+) :12V pin 16Blue,
(-) Trunk Status Input
[1] ( ) T Status InputAC ach
(-) Door Status Input
(-) E-Brake Status Input
(-) Ground
(+) Brake Input
(-) Hood Status Input
HS CAN High: 3Tan/Black:
HS CAN Low: 4Tan:
(-) Ground: 12Brown :/Red
(-) Output:SLP 11Yellow :/Red
(+) 12V :Input 13Red:
(-) Ground: 14Black:
(+) Brake Output: Gray: 6
(-) Hood Status Output: 9Violet/Brown:
Immo Data 1: Yellow/Black: 10
(+) Ignition Status Output: Gray/Black: 7
Immo Data 2: Orange/Black: 11
(-) Push-to-Start Output: Green/Black: 2
(-) Door Status Output: Green/White: 3
(-) Trunk Status Output: Red/Black: 4
[1] ( ) Tach Output: 5AC Violet/White:
(-) E-Brake : 1Status Black/White:
Steering Lock
(black or Blue
c7-pin onnector)
(+) Ignition Input/Output
Remote
Starter
(-) (Status)GWR
(-) OutputLock
(+) Starter Output
(-) OutputUnlock
(-) Trunk Output
1: (-) Lock InputGreen:
2: (-) Unlock InputBlue:
3: (-) Trunk InputRed/White:
8: (+) Starter InputViolet:
10: Blue/White:
(-) (Status) InputGWR
9: (+) Ignition InputPink:
Push-toStart
(black 10-pin onnector)c
ENGINE
START
STOP
2345
109876
1
(-) PTS:
pin 1Dk. Green,
12
3
5
4
7
6
(-) :SLP
Lt. Green,
pin 4
(+) 12V Input
(+) 12V
Not required in D2D mode.
Autolight Interrupt (veh.side): 9Orange/Yellow:
Autolight Interrupt (conn.side): 8Yellow:
Fuse 7.5A
3
18
169
HS CAN High: pin 14Green,
HS CAN Low:,White pin 13
(-) lights:Auto
, pinGreen 28
8
9
7
20
21
19
5
6
17
18
16
29
4
27
15
11
12
10
23
24
22
28
3030
25
26
2
3
1
Body ECU
White 30-pin
onnectorc
(-) Parking Lights Output
Certification ECU
(white 18-pin
onnector)c
1
65
1314
43
1112
8 7
15
16
10 9
1718
2
(+) Start
Enable:
, pinLt. Blue 7
(+) Starter Output
FUSE
BODY ECU
TX
(-) Ground
RX
(+)12V
P#: 2D65XKD
Page 19
Installation Type 7
10
RF
Prog utton. B
LED
4
2
2DBALL
14
12
Unless specified otherwise, all connectors are displayed from the wire side, with the exception of the diagnostic connector.OBDII
[1] Tach wire is an optional connection required on some remote starters, which do not support a tach signal in D2D.
(-) Parking lights:
pin 30White,
Do not connect these wires:
accessory ignition starter,,
from the remote starter to the vehicle.
14
13
BRX: Red,
26pin
BRX: 25Blue, pin