Dirtywave M8 - Page 20

15
Dirtywave M8 Operation Manual
Phrase View Shortcuts
Navigating
• [DIRECTION] Move cursor.
• [OPTION]+[UP or DOWN] Navigate to previous or next phrase in the chain.
• [OPTION]+[LEFT or RIGHT] Navigate to previous or next track.
Playing
• [PLAY] Starts/stops playing phrase.
• [SHIFT]+[PLAY] Continue song at chain position.
• [OPTION]+[SHIFT] Mute current track (release option rst to hold the mute).
• [OPTION]+[PLAY] Solo current track (release option rst to hold the solo).
• [OPTION]+[SHIFT]+[PLAY] Clears all mute and solos.
Editing
• [EDIT] On an empty cell: insert a new value with a default value of the last edited or
deleted value.
• [EDIT]+[UP or DOWN] Edits the selected value on the cursor’s position increment-
ing by large steps. On a command column: show the Eect Help/Selection view.
• [EDIT]+[LEFT or RIGHT] Edits the selected value on the cursor’s position incre-
menting by small steps.
• [EDIT]+[EDIT] (double tap) On the instrument column: set the selected instrument
value to a new unused instrument. On a command value column where the command
is the table or groove command (TBL or GRV): set the value to a new unused table.
• [EDIT]+[OPTION] Deletes/cuts the selected value. In selection mode: cuts the se-
lection into the copy buer.
• [SHIFT]+[OPTION] Enters selection mode for moving, copying, or cutting a block of
phrase data.
• [OPTION] In selection mode: copies the selection and exits selection mode.
• [SHIFT]+[EDIT] Pastes the copy buer that was copied in selection mode. In se-
lection mode: with a series of rows and a single column highlighted: interpolate the
selected range.
• [SHIFT]+[OPTION, then EDIT] On the instrument column or on a command value
column where the command is the table or groove command (TBL or GRV): copy the
contents of the selected data into a new number. (I.e. “clone”).