Dirtywave M8 - Effect Settings View

26
Dirtywave M8 Operation Manual
Eect Settings View
CHORUS SETTINGS
MOD DEPTH 40
MOD FREQ. 80
WIDTH FF
REVERB SEND 00
DELAY SETTINGS
FILTER HP:LP 40:FF
TIME L:R 30:30
FEEDBACK 80
WIDTH FF
REVERB SEND 00
REVERB SETTINGS
FILTER HP:LP 10:E0
SIZE FF
DECAY C0
MOD DEPTH 10
MOD FREQ FF
WIDTH FF
T>120
1 E-3
2 ---
3 ---
4 ---
5 ---
6 ---
7 ---
8 ---
G
SCPI T
M
X
The eect settings view is accessible under the mixer view [SHIFT]+[DOWN].
The M8 has 3 send eects that are utilized by the instrument settings “CHO”, “DEL”
“REV”, as well as on audio and USB input congured in the mixer view.
Chorus
Stereo width eect with subtle modulation. Created by using a stereo delay buer while
smoothly modulating the read position between the left and right channels.
Not recommended for bass heavy sounds.
• MOD DEPTH - The amount of modulation that occurs in the stereo signal.
• MOD FREQ - The speed of the modulation.
• WIDTH - Stereo width. “00” is mono, “FF” is stereo.
• REVERB SEND - Adjusts the amount to send to the reverb eect.
Delay
Ping-pong delay where the incoming audio bounces between left and right channels.
• FILTER HP:LP - high-pass and low-pass lter removing undesired frequencies.
• TIME L:R - Delay time for left and right channels. First digit is in beats, second digit
is in fractions of a beat. Ex: “40” is 4 beats long.
• FEEDBACK - Adjusts the amount that the signal is fed back into itself.
• WIDTH - Stereo width. “00” is mono, “FF” is stereo.
• REVERB SEND - Adjusts the amount to send to the reverb eect.