Dirtywave M8 - Instrument FX Commands

56
Dirtywave M8 Operation Manual
Instrument FX Commands
Almost all parameters for a given instrument type have an FX command associated to it.
Check the FX command help view with the desired instrument in use to see the full list.
Note that highlighting an instrument parameter in the instrument view and navigating
back to the phrase or table will set the default FX command to the selected parameter.
Below is a list of common FX commands for instruments.
VOL XX (Volume)
Oset the instrument volume.
PIT XX (Pitch)
Oset the note pitch in semitones.
FIN XX (Fine tune)
Oset the note pitch from -1 to +1 semitones.
EA[1-2] XX (Envelope Amount)
Oset the Envelope amount.
AT[1-2] XX (Envelope Attack)
Oset the Envelope attack time.
HO[1-2] XX (Envelope Hold)
Oset the Envelope hold time.
DE[1-2] XX (Envelope Decay)
Oset the Envelope decay time.
ET[1-2] XX (Envelope Retrigger)
Retrigger the Envelope. Any value (XX) greater than “00” will retrigger the envelope.
LA[1-2] XX (LFO Trigger)
Oset the LFO amount.
LF[1-2] XX (LFO Frequency)
Osett the LFO frequency.
LT[1-2] XX (LFO Retrigger)
Retrigger the LFO. The value (XX) sets the desired phase oset (start position) of the
LFO.