Dirtywave M8 - Macrosynth

38
Dirtywave M8 Operation Manual
Macrosynth
INST. 00
TYPE MACROSYN LOAD SAVE
NAME ------------
SHAPE 00CSAW
TIMBRE 80
COLOR 80
DEGRADE 00
REDUX 00
FILTER 00OFF
CUTOFF FF
RES 00
PAN 00
DRY C0
CHO 00
DEL 00
REV 00
T>120
1 ---
2 ---
3 ---
4 ---
5 ---
6 ---
7 ---
8 ---
P
SCPI T
M
TRANSP. ON
TABLE TIC 01
AMP 00
LIM 00CLIP
The Macrosynth contains 44 dierent models or “SHAPES”. From basic analog to 2-op
FM, physical modeling, and percussive sounds. The two parameters “TIMBRE” and
“COLOR” control the overall characteristics and change depending on the shape se-
lected. Refer to the Macrosynth Models section in the appendix for details.
Macrosynth Parameters
• SHAPE - Select one of the 44 dierent engines. Refer to the Macrosynth Models
section in the appendix for details.
• TIMBRE - First parameter of the Macrosynth shape.
• COLOR - Second parameter of the Macrosynth shape.
• DEGRADE - Sample rate reduction eect.
• REDUX - Bit rate reduction eect.
Multi-mode Filter Parameters
• FILTER - Filter type - Lowpass, Highpass, Bandpass, and Bandstop.
• CUTOFF - Filter cuto frequency.
• RES - Filter resonance amount.
Amplication Parameters
• AMP - Amplies the waveform. Any value higher than the maximum level allowed is
handled according to the “LIM” setting.