Dirtywave M8 - M8 Device Overview and Setup; Powering Up and Charging

3
Dirtywave M8 Operation Manual
Overview
Physical Layout
Powering Up
The power button is located on the right side of the unit. Press the button for 1 second
to turn on, 2 seconds to turn o. The button is slightly recessed by design to prohibit
unintentional power cycles when stored.
Note: If a software crash occurs or unit is non-responsive, you can power down the unit
by depressing the button for 7 seconds. The unit can be powered back on to continue
normal operation. Please report crashes to support@dirtywave.com.
Charging
Charge the unit with the included Micro USB cable and an adequate USB power source
(500mA - Standard USB). Battery level and charging indicator status can be found at
the top right of the display. The M8 is charging when the battery icon is animating. You
can operate the M8 while it is charging, however please allow the M8 to fully charge for
the rst time before using it without external power.
SONG
12345678
00>00 -- -- -- -- -- -- --
01 -- -- -- -- -- -- -- --
02 -- -- -- -- -- -- -- --
03 -- -- -- -- -- -- -- --
04 -- -- -- -- -- -- -- --
05 -- -- -- -- -- -- -- --
06 -- -- -- -- -- -- -- --
07 -- -- -- -- -- -- -- --
08 -- -- -- -- -- -- -- --
09 -- -- -- -- -- -- -- --
0A -- -- -- -- -- -- -- --
0B -- -- -- -- -- -- -- --
0C -- -- -- -- -- -- -- --
0D -- -- -- -- -- -- -- --
0E -- -- -- -- -- -- -- --
0F -- -- -- -- -- -- -- --
T>120
1 E-3
2 ---
3 ---
4 ---
5 ---
6 ---
7 ---
8 ---
P
SCPIT
M
AUDIO USB MIDI
OPTION EDIT
PLAY
SHIFT
Micro SD - Use suggested
cards in proper format
dirtywave.com/sd
USB power, audio, MIDI,
and virtual display.
MIDI Input (TRS Type A)
MIDI Output (TRS Type A)
Refer to the key command
section of this manual
Battery level indicator
Current song tempo
Track note monitor
Power button
(Press to power on/off)
Screen navigation position
(Mini-map)
Stereo audio Input
(Line-level only)
Headphone/audio output