44
Dirtywave M8 Operation Manual
FM Synth
INST. 00
TYPE FMSYNTH LOAD SAVE
NAME ------------
ALGO 00A>B>C>D
A SIN B SIN C SIN D SIN
RATIO 01.00 02.00 01.01 01.00
LEV/FB 80/ 00 80/ 00 80/ 00 80/ 00
MOD 1>LEV ----- 2>PIT -----
----- ----- ----- -----
MOD1 FF
MOD2 00
MOD3 00
MOD4 00
FILTER 00LOWPASS
CUT FF
RES 00
PAN 00
DRY C0
CHO 00
DEL 00
REV 00
AMP 00
LIM 00CLIP
T>120
1 ---
2 ---
3 ---
4 ---
5 ---
6 ---
7 ---
8 ---
P
SCPI T
M
TRANSP. ON
TABLE TIC 01
FM Synth is a uniquely simple four operator 12 algorithm FM (frequency modulation)
synthesizer. Each of the four operators can have one of 12 base shapes with ratio, level,
feedback, and two modulation slots for assigning one of the four modulation macros to
control the parameters.
FM Synth Parameters
• ALGO - Select one of 12 algorithm (oscillator routing) congurations. Use the last
algorithm to use “additive mode”- 4 oscillator subtractive synth. See the algorithm
diagram on the next page.
• A / B / C / D - The operator letter with optional shape. See the shapes diagram on
the next page.
• RATIO - Frequency ratio relative to the currently playing note. Ex: “2.00” will play an
octave up, “0.50” will play an octave lower.
• LEV/FB - Volume and Feedback for each operator.
• MOD - Two modulation slots that assign MOD[1 to 4] to control a destination on the
given operator.
• LEV - Controls the level from “00” to the currently set level.
• RAT - Adds 0.00 to +16.00 to the current ratio.
• PIT - Adds to the note pitch in semitones for the current operator.
• FBK - Controls the feedback from “00” to the currently set feedback.
• MOD[1-4] - The modulation source values that are freely assigned to the operators
via the “MOD” slots described above.
To Next Page
Loading...
