Dirtywave M8 - Mixer & Effects Commands

54
Dirtywave M8 Operation Manual
Mixer & Eects Commands
VMV XX (Main Volume)
Set the main song volume. Changes the value located in the Mixer view.
XCM XX (Send Eect: Chorus Mod Depth)
Set the chorus mod depth. Changes the value located in the Send Eects settings view.
XCF XX (Send Eect: Chorus Mod Frequency)
Sets the chorus mod frequency. Changes the value located in the Send Eects settings
view.
XCW XX (Send Eect: Chorus Stereo Width)
Sets the chorus stereo width. Changes the value located in the Send Eects settings
view.
XCR XX (Send Eect: Chorus to Reverb Mix)
Sets the chorus reverb send amount. Changes the value located in the Send Eects
settings view.
XDT XY (Send Eect: Delay Time)
Sets the left (X) and right (Y) delay times in large increments. Changes the value located
in the Send Eects settings view.
XDF XX (Send Eect: Delay Feedback)
Sets the delay feedback amount. Changes the value located in the Send Eects set-
tings view.
XDW XX (Send Eect: Delay Stereo Width)
Sets the delay stereo width. Changes the value located in the Send Eects settings
view.
XDR XX (Send Eect: Delay to Reverb Mix)
Sets the delay reverb send amount. Changes the value located in the Send Eects set-
tings view.
XRS XX (Send Eect: Reverb Room Size)
Sets the reverb room size. Changes the value located in the Send Eects settings view.
XRD XX (Send Eect: Reverb Decay)
Sets the reverb decay. Changes the value located in the Send Eects settings view.