Dirtywave M8 - Page 42

37
Dirtywave M8 Operation Manual
Wavsynth Parameters (Continued)
• WARP - Push the shape to one side of the wave table.
• MIRROR - Mirrors the waveform at the specied position, the value range is from 0
to 200%. Note this will do nothing on triangle waveforms since the triangle is a mirror
reection at center.
Multi-mode Filter Parameters
• FILTER - Filter type - Lowpass, Highpass, Bandpass, and Bandstop. Note Wavsynth
has 4 extra modes which apply the lter into the waveform: “WAV LP” - Lowpass,
“WAV HP” - Highpass, “WAV BP” - Bandpass, and “WAV BS” Bandstop.
• CUTOFF - Filter cuto frequency.
• RES - Filter resonance amount.
Amplication Parameters
• AMP - Amplies the waveform. Any value higher than the maximum level allowed is
handled according to the “LIM” setting.
• LIM - Set the limit / clipping behavior of the amplied signal.
• CLIP - Any value higher than the maximum level is clipped.
• SIN - The waveform is fed through a sine function.
• FOLD - Any value higher than the maximum level is folded back into itself.
• WRAP - Any value higher than the maximum level is vertically wrapped.
• POST - The amplication is applied with soft-clipping after the lter stage.
Mixer Parameters
• DRY - Dry volume sent to the mixer channel.
• CHO - Chorus send eect volume.
• DEL - Delay send eect volume.
• REV - Reverb send eect volume.