Dirtywave M8 - Page 46

41
Dirtywave M8 Operation Manual
Sampler Parameters (Continued)
• OSC REV - Oscillator reverse mode.
• OSC PP - Oscillator ping-pong mode.
• START - Sample start position. This parameter is ignored when in “OSC” play modes.
• LOOP ST. - Loop start position. When in a looping play mode, sample will loop back
to this position after it reaches the end.
• LEN - Sample length.
• DETUNE - Detune sample with “80” being the center frequency. First digit incre-
ments semitones, second increments 1/16 semitone.
• DEGRADE - Sample rate reduction eect. Any value above “00“ disables sample
interpolation.
Multi-mode Filter Parameters
• FILTER - Filter type - Lowpass, Highpass, Bandpass, and Bandstop.
• CUTOFF - Filter cuto frequency.
• RES - Filter resonance amount.
Amplication Parameters
• AMP - Amplies the waveform. Any value higher than the maximum level allowed is
handled according to the “LIM” setting.
• LIM - Set the limit / clipping behavior of the amplied signal.
• CLIP - Any value higher than the maximum level is clipped.
• SIN - The waveform is fed through a sine function.
• FOLD - Any value higher than the maximum level is folded back into itself.
• WRAP - Any value higher than the maximum level is vertically wrapped.
• POST - The amplication is applied with soft-clipping after the lter stage.
Mixer Parameters
• DRY - Dry volume sent to the mixer channel.
• CHO - Chorus send eect volume.
• DEL - Delay send eect volume.
• REV - Reverb send eect volume.