©
2019 DJI All Rights Reserved.
35
AGRAS T16
User Manual
1. Power on the remote controller and open DJI MG2 . Power on the aircraft.
2. Tap Perform an Operation to enter Operation View and tap
, then . Select Aircraft as the linking
device, tap Single Linking or Multi Linking (if Multi-Aircraft Control is in use), and then tap Starting
Linking. The status LED blinks blue and the remote controller sounds a repeated double beep,
indicating that the remote controller is ready for linking.
Linking …
Press the aircraft’s linking button to continue
End linking
3. Press and hold the power button on the Intelligent Flight Battery for five seconds. The aircraft front
LEDs blink red and green alternately, indicating that the linking is in progress.
4. The Status LED on the remote controller glows solid green and the aircraft front LEDs blinks red
several times if linking is successful. If linking fails, enter linking status again and retry.
5. Repeat Step 3 and 4 to complete linking between all the aircraft and the remote controller, if Multi
Linking is selected. When finished, tap End Linking. Note that up to five aircraft can be linked.
Multi-Aircraft Control Function
The remote controller features a Multi-Aircraft Control function, which can be used to coordinate the
operation of up to five aircraft at the same time, enabling pilots to work very efficiently. It is recommended
for large spray areas. Turn the aircraft control switch dial on the remote controller to switch between
different aircraft for single control of the desired aircraft.
The Multi-Aircraft Control function can only be used in Route operation mode. Make sure to
complete field planning and related configurations before entering the Multi-Aircraft Control
mode, since operations of other modes cannot be used except for Route operation mode.
To avoid interference between operations, do not operate more than three groups within a 50 m
radius when using the Multi-Aircraft Control function. Unless using the T16 with a DJI D-RTK 2
Mobile Station, it is necessary to manually configure the serial number of each remote controller
in DJI MG2.
Enter Multi-Aircraft Control Mode
1. Link all the aircraft (up to five) to the same remote controller according to the steps in Linking the
Remote Controller.
2. Close the settings menu after linking. The linked aircraft are listed on the left of the screen and sorted
by number.
Switch Control
Users can switch control among different aircraft via the aircraft status box on the left of the screen in the
app or the aircraft control switch dial on the remote controller.
To Next Page
Loading...
