dji AGRAS T16

©
2019 DJI All Rights Reserved.
25
AGRAS T16
User Manual
Maintain full control of the aircraft at all times. DO NOT rely solely on DJI MG2. Keep the
aircraft within VLOS at all times. Use your sound discretion to operate the aircraft manually to
avoid obstacles.
Comply with local radio transmission laws and regulations.
The radar module can only function properly in flat landscapes. It cannot function in sloping
landscapes with inclinations more than 10° or in landscapes with sudden changes in
elevation.
The sensitivity of the radar module may be reduced when operating several aircraft within a
short distance. Operate with caution.
Before use, make sure that the radar module is clean and the outer protective cover is not
cracked, chipped, sunken, or misshapen.
DO NOT attempt to disassemble any part of the radar module that has already been mounted
prior to shipping.
The radar module is a precision instrument. DO NOT squeeze, tap, or hit the radar module.
Land the aircraft on flat ground to avoid damage to the radar module from raised objects.
If the radar module frequently detects obstacles incorrectly, first check to make sure the
mounting bracket and the aircraft landing gear are properly secured. Second, perform
the IMU calibration. If the radar module still does not work, contact DJI Support or a DJI
authorized dealer.
Keep the protective cover of the radar module clean. Clean the surface with a soft damp cloth
and air dry before using again.
Empty Tank
Prole
A prompt appears in DJI MG2 and the aircraft hovers in place when the spray tank is empty. In Route, A-B
Route, and Manual Plus operation modes the aircraft can also be set to ascend or RTH instead of hovering.
Usage
1. When an empty tank warning appears in the app, the sprinklers automatically turn off.
2. Make sure that the aircraft is in Manual operation mode. Land the aircraft and stop the motors. Refill
the spray tank and tightly secure the cover.
3. Take off in Manual operation mode and fly the aircraft to a safe position. Enter the desired mode to
continue the operation.
Return to Home (RTH)
Home Point: The default home point is the first location where your aircraft received strong
GNSS signals
(the white GNSS icon has at least four white bars). The aircraft status
indicators blinks several times after the home point has been recorded.
RTH: RTH brings the aircraft back to the last recorded home point.
There are two types of RTH: Smart RTH and Failsafe RTH.