dji AGRAS T16

©
2019 DJI All Rights Reserved.
49
DJI Assistant 2 for MG
Configure settings of the basic parameters, copy flight records, and update aircraft and remote controller
firmware in DJI Assistant 2 for MG.
Installation and Launching
1. Download the DJI Assistant 2 for MG installation file from the T16 download page:
http://www.dji.com/t16/info#downloads
2. Install the software.
3. Launch DJI Assistant 2 for MG.
Using DJI Assistant 2 for MG
Connecting the Aircraft
Connect the USB-C port on the bottom of the aerial-electronics system of the aircraft to a computer with
a USB-C cable, and then power on the aircraft.
Make sure to remove the propellers before using DJI Assistant 2 for MG.
Remove the waterproof cover on the USB-C port before use. Attach the waterproof cover to the
port after use. Otherwise, water may enter the port, causing it to short circuit.
Firmware Update
A DJI account is required for firmware updates. Login or register an account.
Basic Settings
Configure the idle speed of and test the motor.
Tools
Enter SD card mode and copy the flight record.
Connecting the Remote Controller
Connect the USB-C port of the remote controller to a computer with a USB-C cable, and then power on
the remote controller.
Firmware Update
A DJI account is required for firmware updates. Login or register an account.
DO NOT power off the remote controller during the update.
DO NOT perform the firmware update while the aircraft is in the air. Only carry out the firmware
update when the aircraft is on the ground.
The remote controller may become unlinked from the aircraft after the firmware update. Relink
the remote controller and aircraft if necessary.