dji AGRAS T16

©
2019 DJI All Rights Reserved.
45
AGRAS T16
User Manual
bubbles in the hoses have been fully discharged.* Tighten the valves and press the spray button
to stop spraying.
* If the bubbles have still not been fully discharged after an extended period, rotate and remove the valve cover. Reattach
the cover once the bubbles have been fully discharged.
2. Spraying System Calibration
1
Make sure that there is more than 6 L of water in the spray tank. In DJI MG2, tap Execute
Operation to enter Operation View, tap
, then , and select the correct nozzle model. The
standard nozzle is model XR11001VS.
2
Tap Calibrate. Select the pumps that require calibration and tap Calibration. Note that all four
pumps are selected by default.
3
Calibration starts automatically. After several minutes, the result of the calibration is displayed in
the app.
After calibrating successfully, users can proceed with the operation.
If calibration fails, tap “?” to view and resolve the problem. Afterwards, select the pump that
failed to calibrate.
During calibration, tap , then to cancel. If the calibration is cancelled, the accuracy of the
flow meter is based on the data before the calibration was started.
When to Recalibrate
1. Installing a different nozzle model. Note: Choose the corresponding model in DJI MG2 after replacing
nozzles. Go to Operation View, tap
, then for configuration.
2. Using a liquid of a different viscosity.
3. The error between the actual value and the theoretical value of the completed area is more than 15%.
Calibrating the Compass
It is important to calibrate the compass. The calibration result affects the flight safety. The
aircraft may malfunction if the compass is not calibrated.
DO NOT calibrate your compass where there is a chance of strong magnetic interference.
This includes areas where there are utility poles or walls with steel reinforcements.
DO NOT carry ferromagnetic materials with you during calibration such as keys or mobile phones.
If the aircraft status indicators show a blinking red light, compass calibration has failed. Please
recalibrate.
After calibrating successfully, the compass may be abnormal when you place the aircraft on
the ground. This may be because of underground magnetic interference underground. Move
the aircraft to another location and try again.
Calibrate the compass when prompted by the app. It is recommended to calibrate the compass with an
empty tank
1. Tap
, then , move the slider to the bottom, and select Advanced Settings, then Sensors. Tap
Calibration in the compass calibration section.