dji AGRAS T16

44
©
2019 DJI All Rights Reserved.
AGRAS T16
User Manual
With a strong GNSS signal
Area Restriction Aircraft Status Indicators
Restricted
Zone
Motors will not start.
Blinking Red
If the aircraft loses GNSS signal and enters a
Restricted Zone but regains GNSS signal later, the
aircraft will enter semi-automatic descent and land.
No Flight
Restrictions
Users can fly their aircraft freely. None.
Semi-Automatic Descent: All stick commands except the throttle stick command are available
during descent and landing. Motors automatically stop after landing.
When operating in Restricted Zones, the aircraft status indicators blink red slowly and
continue for five seconds, and then switch to the current aircraft status for twelve seconds. If
the aircraft is still in the Restricted Zone at that point, it switches to blinking red slowly for five
seconds again and so on.
DO NOT fly near airports, highways, railway stations, railway lines, city centers, or other busy
areas. Make sure the aircraft is visible at all times.
Pre-Flight Checklist
1. Make sure the remote controller and aircraft battery are fully charged. The pesticides required are
adequate.
2. Make sure the spray tank and Intelligent Flight Battery are firmly in place.
3. Make sure all parts are mounted securely.
4. Make sure all cables are connected properly and firmly.
5. Make sure propellers are securely mounted, that there are no foreign objects in or on the motors and
propellers, that the propeller blades and arms are unfolded, and the arm sleeves are firmly tightened.
6. Make sure the spraying system is not blocked in any way.
7. Make sure the sprinkler hoses are clear from bubbles. Discharge any bubbles as they may affect the
performance of the sprinkler. Loosen the valve on the side of the spray nozzle and start the pump.
Next, tighten the valve and the sprinkler will work properly.
Calibrating the Spraying System
Make sure to calibrate the spraying system before using for the first time. Otherwise, the spraying
performance will be adversely affected.
1. Preparation before calibration: If there are any bubbles in the hoses, discharge them before
calibrating. If there are no bubbles, proceed with calibration.
1
Fill the spray tank with approximately 10 L of water.
2
Loosen all the manual relief valves and press the spray button on the remote controller until the