dji AGRAS T16

©
2019 DJI All Rights Reserved.
47
AGRAS T16
User Manual
2. When the aircraft has landed, push the throttle stick down, and perform the same CSC that was used
to start the motors. Release both sticks once the motors have stopped. Release both sticks once the
motors have stopped.
OR
Throttle Stick
Starting and Stopping the Motors
Starting the Motors
The Combination Stick Command (CSC) listed below is used to start and stop the motors. Make sure
you perform the CSC in one continuous motion. The motors begin to accelerate at an idle speed.
Release both sticks simultaneously. Take off immediately once the motors are spinning, or else the
aircraft may lose balance, drift, or even takeoff by itself and risk causing damage or injury.
OR
Stopping the Motors
There are two methods to stop the motors.
1. When the aircraft has landed, push and hold the throttle stick down. The motors will stop after three
seconds.
Throttle Stick (left stick in Mode 2)
Spinning propellers can be dangerous. Stay away from spinning propellers and motors. DO
NOT start the motors in confined spaces or when there are people nearby.
Keep your hands on the remote controller when the motors are spinning.
DO NOT stop the motors mid-flight unless in an emergency situation where doing so will
reduce the risk of damage or injury.
Method 1 is the recommended method for stopping the motors. When using Method 2 to
stop the motors, the aircraft may roll over if it is not completely grounded. Use Method 2 with
caution.
After landing, power off the aircraft before turning off the remote controller.