dji AGRAS T30 - Page 15

©
2022 DJI All Rights Reserved.
13
AGRAS T30
Unmanned Aircraft Flight Manual
External Battery
Charge the external Intelligent Battery using the included AC power adapter and charging hub.
1. Place the battery into the charging hub, connect the AC power adapter to the charging hub, and
connect the charger to a power outlet (100-240 V, 50/60 Hz).
2. The charging hub automatically charges batteries in order according to the battery power levels from
high to low.
3. The Status LED blinks green when charging and turns solid green when fully charged. The charging
hub beeps when charging is complete. To stop the beeping, remove the battery or turn off the button
on the charging hub.
AC Power AdapterCharging Hub
Power Outlet
Fully charge and discharge the battery at least once every three month.
USB power supply port can be used to charge the mobile device of 5V/2A.
Status LED Description
Blinks Green Charging
Solid Green Fully charged
Blinks Red Battery charger error. Retry with an ofcial battery charger
Solid Red Battery error
Blinks Yellow Battery temperature too high/low. Temperature must be within
operating range (5°to 40°C (41°to 104° F))
Solid Yellow Ready to charge
Blinks Green Alternately Intelligent Battery not detected