dji AGRAS T30 - Page 49

©
2022 DJI All Rights Reserved.
47
AGRAS T30
Unmanned Aircraft Flight Manual
If, after recording Points A and B, you y the aircraft more than ve meters away from Point
B, Resume appears at the lower right corner of the screen. Tap Resume, and the aircraft
automatically ies to Point B to perform the operation.
If the GNSS signal is weak during the operation, the aircraft enters Attitude mode and exits
from A-B Route operation mode. Operate the aircraft with caution. The operation can be
resumed after the GNSS signal is recovered.
If you press the A or B button during operation while the ying speed of the aircraft is lower
than 0.3 m/s, the data for Points A and B of the current route is erased and the aircraft hovers
in place.
Users cannot control the aircraft heading via the control stick during the operation.
When using the control sticks to control the aircraft in A-B Route operation mode, the aircraft
automatically switches to Manual operation mode, completes the corresponding flight
behavior, and then hovers. To resume the operation, tap Resume onscreen. The aircraft
resumes ying along the operation route. Refer to Operation Resumption for more information.
Even though the heading of the aircraft cannot be adjusted, use the control sticks to avoid
obstacles if the obstacle avoidance function of the radar module is disabled. Refer to Manual
Obstacle Avoidance for more information.
During the operation, the aircraft does not spray liquid while ying along the route parallel to the
line from A to B, but automatically sprays liquid while ying along the other parts of the route.
Manual Operation Mode
Tap the operation mode switch button in the app and select M to enter Manual operation mode. In this
mode, you can control all the movements of the aircraft, spray liquid via the spray button of the remote
controller, and adjust the spray rate via the dial. Refer to Controlling the Spraying System for more
information. Manual operation mode is ideal when the operating area is small.
Manual Plus Operation Mode
Tap the operation mode switch button in the app and select M+ to enter Manual Plus operation mode.
In this mode, the maximum ying speed of the aircraft is 7 m/s (customizable in the app), the heading
is locked, and all other movement can be manually controlled. Users can disable the M+ heading
lock in Parameters Conguration. Under optimal working conditions, the radar module maintains the
spraying distance between aircraft and vegetation if the altitude stabilization function is enabled. Press
the corresponding buttons onscreen or customizable buttons on the remote controller (if customized)
to steer the aircraft left or right. The aircraft automatically sprays when accelerating forward, backward
or diagonally, but does not spray when ying sideward. Manual Plus operation is ideal for irregularly-
shaped operating areas.
The route spacing cannot be adjusted during operation. Switch to Manual operation mode to
adjust the value, then return to Manual Plus operation mode.
The spray rate will be adjusted automatically according to the ying speed.
In the app, users can adjust the spray amount, ying speed and height above the vegetation.