dji AGRAS T30 - Page 57

©
2022 DJI All Rights Reserved.
55
AGRAS T30
Unmanned Aircraft Flight Manual
Reassembly
Identify the CW or CCW marks on the propeller blades and motors. Make sure to assemble the parts
with the same mark.
1. Place the one rubber washer and then two Teflon gaskets onto one of the mounting hole on the
motor. Place the propeller blade and then two Teon gaskets and one rubber washer.
2. Follow the same steps for the other mounting hole on the motor.
3. Place the propeller adapter on the top.
4. Insert the two M5×15 screws to the mounting holes and tighten to secure the propeller blades.
Nozzles
Disassembly
Rotate and remove the nozzle buckle and disassemble the nozzle sealing ring, nozzle, and nozzle
locating ring.
Reassembly
Mount the nozzle locating ring to the nozzle and mount them to the nozzle buckle. Place the nozzle
sealing ring into the buckle. Mount the buckle to the sprinkler and rotate to secure it.
Storage
Aircraft Storage
1. Keep the aircraft and parts clean and dry and store them in a cool dry place. Recommended storage
temperature (when the tank, ow meter, pumps, and hoses are empty): between -20° and 40° C (-4°
and 104° F).
2. Make sure to keep the small parts properly to avoid loss. Small parts, such as cables and straps, are
dangerous if swallowed. Keep all parts out of reach of children and animals.
3. Remove or empty the tank when not in use to avoid damaging the landing gear.
4. Remove the battery from the aircraft when stored.
Battery Storage
Disconnect the battery from the aircraft and check if there is any buildup in the battery port.
Power off and disconnect the battery from the aircraft during transportation.
Keep batteries out of the reach of children and animals. Seek professional medical support
immediately if children swallow parts of the battery.
If the battery level is critically low, charge the battery to a power level of 40% to 60%. DO NOT
store a battery with a low power level for an extended period. Otherwise, the performance will
be negatively affected.
DO NOT leave the battery near heat sources such as a furnace or heater. DO NOT leave the
battery inside a vehicle on hot days.
The battery must be stored in a dry environment.
DO NOT place the battery near explosive or hazardous material or near metal objects such as
eyeglasses, watches, jewelry, and hairpins.
DO NOT attempt to transport a battery that is damaged or has more than 30% power.
Discharge the battery to 30% or lower before transportation.
• Make sure the battery is placed on a at surface.