Ronin 2
User Manual
24
©
2017 DJI OSMO All Rights Reserved.
Stiffness: Select the mounting mode prior to adjusting the Stiffness value. The motor
stiffness adjustment allows you to ne-tune the amount of power that is applied by the
motors as they react and balance the weight on each axis. Please make sure you leave
an extra margin for this setting to ensure stability at all times. For example, if the Pan axis
starts to shake at a stiffness of 40, then lower the value to 32. When shooting in Handheld
mode, if the stiffness value set for the roll axis is 20, but the roll axis shaking affects
the footage, that means the stiffness value is too low to provide optimal stability. Try
increasing the stiffness value to 30.
Strength: It is recommended to leave this setting as default. The motor strength
adjustment allows you to minimize Ronin 2’s attitude error. This parameter affects how
quickly the Ronin 2 will react to changes in orientation. If you see any unusual attitude
errors (more than 1 in the readings), you may minimize it by increasing the corresponding
motor’s strength. However, increasing strength too much may also cause the Ronin 2 to
over adjust its orientation and induce shakiness. When the Strength value is set to 10, and
the pan axis cannot stop immediately after a fast rotation, try to decrease the value to 6.
Filter: This setting can ease high-frequency vibrations of the Ronin 2. When the Ronin 2 is
vibrating at a high frequency, you may experience numbness while touching the gimbal
motors of each axis. In such instances, it is recommended to lower the Filter settings.
Control: It is recommended to leave this setting as default. Control can guide the Ronin 2
to better handle low-frequency vibrations. If your Ronin 2 vibrates at a visible range, you
can suppress it by increasing Control. When the vibration persists at low frequency, then
decrease Control. Adjusting Control to optimal settings may take readjustment.
Payloads (kg)
Stiffness Strength Filter Control
Pan Tilt Roll Pan Tilt Roll Pan Tilt Roll Pan Tilt Roll
0 10 6 10 10 10 10 30 45 45 26 28 28
0-2 kg 25 20 20 10 10 10 30 45 45 26 28 28
2-4 kg 35 30 30 10 10 10 30 45 45 26 28 28
4-6 kg 40 40 35 10 10 10 30 40 40 26 28 28
6-8 kg 45 45 40 10 10 10 25 35 35 26 28 28
8-10 kg 50 50 40 10 10 10 25 35 35 26 28 28
10-12 kg 55 55 45 10 10 10 20 30 30 26 28 28
12-13.6 kg 60 55 45 10 10 10 20 25 25 26 28 28
Remarks
The values above
are for reference.
You can adjust
the value within
a value of 10 as
needed.
It is recommended
to use default
settings.
The values above
are for reference.
You can adjust
the value within
a value of 10 as
needed.
It is recommended
to use default
settings.
It is recommended to use the remote controller to test the pan and tilt axis. Control
the pan and tilt axis to all angles to see if shaking occurs. It is normal if the pan or
tilt axis shakes one time and doesn’t shake after that.
To Next Page
Loading...
