DLS FlexxPump 125 - Operation and Settings; 6.1 General Operating Information

BA FlexxPump 125 - 24 V_20181121_EN de 201811 19
Operation
5.6 Triggering a Single Lubrication Process
You can trigger a single lubrication process with the FlexxPump 125 at any time during
operation.
MAX1
9 FlexxPump 125 in operation (PAU / On)
1. Hold the magnetic pin against the area of activity.
The LED ashes red.
2. Remove the magnetic pin when run is displayed.
The FlexxPump 125 performs a single lubrication process.
The LCD displayed the approximate counter-pressure and the pumping pump piston.
The FlexxPump 125 starts operating again automatically at the end of the lubrication
process.