DLS FlexxPump 125 - Changing Parameters in the Expert Menu

BA FlexxPump 125 - 24 V_20181121_EN de 201811 21
Operation
5.8 Changing Parameters in the Expert Menu
Note
Changes in the Expert menu can inuence the functionality of the FlexxPump 125
fundamentally. Only change the parameters in the Expert menu when you are aware what
the e󰀨ects will be.
The following parameters can be set in the Expert menu:
• Pulse mode Pu
• Emptying time t
• Number of cycles C
• Pressure P
• Cartridge size U
• Inversion of the output signals E
• Empty signal L
• Feedback / motor running check F
A description of the individual parameters can be found in chapter 5.1 Adjustable
Parameters.
Note
The emptying time can only be set in the FlexxPump 125 if it not controlled by an external
controller (Pu0).