Digital Monitoring Products, Inc. | 7800 Series Installation and Programming Guide 13
MOUNT THE KEYPAD
All DMP keypad housings are designed to install on any 4” square box, 3-gang switch box,
compatible backboxes, or directly on a flat surface. For more information about mounting
accessories, refer to “Ordering Information”.
1. Ensure all cables are routed through the keypad base cut outs before fully
mounting the base to the wall. See Figure 10.
2. Use #6 screws to secure the keypad base to the surface.
3. Place the keypad cover back onto the base and snap into place.
To Next Page
Loading...
Need help?
General
