DMP Electronics XT50 User Manual

User Menu XT30/XT50 User Guide 35
Using the Zone Monitor Function
1. Access the User Menu.
2. Press the CMD key until ZONE MONITOR? displays.
3. Press any select key or area.
The keypad displays PERIM ALL NBR.
4. Select PERIM to place all perimeter zones into Zone Monitor.
4a. The keypad dis`plays PERIM? ADD RMV.
4b. Select ADD to add all perimeter zones to Zone Monitor.
4c. Select RMV to remove all perimeter zones.
5. Select ALL to place all zones into Zone Monitor.
5a. The keypad displays ALL? ADD RMV.
5b. Select ADD to add all disarmed zones to Zone Monitor.
5c. Select RMV to remove all disarmed zones.
6. Select NBR to enter a specic zone number for zone monitor.
7. If NBR is selected, the keypad displays ZONE : - ADD RMV.
7a. Enter any zone number and select ADD to add this zone.
7b. Enter any zone number and select RMV to remove the
zone.
8. The zone number automatically disappears and a new zone
number can then be entered. See step 7.
System Test
User Code Level: Master, Standard, or Limited.
Function: System Test is used to test the battery, alarm bell or
siren, and central station communi cation. The System Test function
begins automatically as soon as you select it.
Using the System Test Function
1. Access the User Menu.
2. Press the CMD key until SYSTEM TEST? displays.
3. Press any select key or area. The system test begins
automatically and the keypad displays:
1) BELL SOUNDING during a two second bell test, then:
2) KEYPAD SOUNDING during a two second keypad test, then:
3) BATTERY - OKAY or BATTERY - TRBL to indicate the
battery condition, then:
4) TRANSMIT TEST * and ATTEMPT NO : 1 during the
transmit test, then:
5) TRANSMIT OKAY or TRANSMIT FAILED to show the transmit
test results, then:
6) TEST END to indicate the System Test is complete.
7) Press the Back Arrow key to end the system test.
* The transmit test does not occur on local systems.
Testing your system burglary protection: The System Test function
should be part of your weekly testing and should be followed by
placing the interior and perimeter burglary devices in Zone Monitor
mode. This allows you to open and then close each protected door
and window while listening for the keypad to beep conrming its
operation. See Zone Monitor.

DMP Electronics XT50 Specifications

General

Brand	DMP Electronics
Model	XT50
Category	Control Panel
Language	English