Do not charge the waste batteries. If you find that the battery charging is abnormal, please
do not charge it by force and replace it with a new one to avoid accidents.
Recharge only with the charger specified by the manufacturer. A charger that is suitable
for one type of battery pack may create a risk of fire when used with another battery pack.
Use power tools only with specifically designated battery packs. Use of any other battery
packs may create a risk of injury and fire.
When battery pack is not in use, keep it away from other metal objects, like paper clips,
coins, keys, nails, screws or other small metal objects, that can make a connection from
one terminal to another. Shorting the battery terminals together may cause burns or a fire.
Under abusive conditions, liquid may be ejected from the battery; avoid contact. If
contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek
medical help. Liquid ejected from the battery may cause irritation or burns.
1.5 Hazards of Incorrect Operation
Incorrect operation, excessive tension, improper use of packing straps, sudden loss of
tension force due to loading of sharp objects, or breakage of straps may eventually lead
to:
The operator falling down as a result of out of balance.
Personal harm as a result of the tool and the strap whipping out to the operator quickly.
Attention:
a. If the load object is sharp, please add edge protection between the strap and the object.
b. Please wrap the packing straps around the object correctly.
c. In the process of operation, the operator should stand beside the machine and the strap,
instead of in front and back of the machine and the strap. If the operator operates the
machine by standing in a straight-line position with the tool, he may be injured by the
machine or the strap that strikes forward or backward towards him due to improper
operation. Keep away from bystanders during operation. Please use a strap of qualified
quality recommended in this manual. A qualified strap shall have suitable width,
thickness and strength. Unqualified straps may result in strap breakage during strap
tensioning, causing hazards.
1.6 Straps Dispenser
Please use professional straps dispenser to work with the machine. After finished the
operation, please fold the end of the strap into the straps dispenser.
1.7 Welding Effects
When it is found that the straps welding joint is unqualified(refer to 5.3 for the welding
joint standard), please cut off the strap and operate again.
Unqualified strap welding may lead to unsecure strapping, which may cause serious
damage during shipping process, bringing a safety hazard.
To Next Page
Loading...