1.8 Correct Strap Cutting
Please cut off the strap with a suitable cutting tool and ensure a safe distance between
the strap and the operator. Do not stand in a same straight line as the strap, and stay away
from the loose direction of the strap, to prevent the operator from being injured by the
bounced strap due to sudden breakage of the strap.
Please use professional tools for cutting straps. Hammers, pliers, hacksaws, axes, etc. are
not allowed.
1.9 Regular Maintenance
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained;
Regularly maintain the tool to keep it in a good working condition;
Regularly check for broken or worn parts. If there are broken or worn parts, please replace
the parts in time before using it;
It is recommended to clean the machine regularly (every day) if it is used in a dirty
environment. Remove impurities such as debris in the tensioning and welding areas of the
tool with an air gun(or other dust extraction tool), and observe it with naked eyes at the same
time. If the tool is obviously damaged, please repair it and replace parts in time;
The battery needs to be charged every six months if it is not used in a long time;
Most parts of the tool need to be replaced and repaired when the number of strapping
beats reaches more than 100,000 to avoid personal injury caused by tool failure;
Please consult the supplier if you need to purchase spare and accessory parts;
Do not modify the strapping machine without permission, otherwise it may cause
personal injuries.
2. TECHNICAL PARAMETERS
2.1 Machine Introduction
Q31 series electric battery powered strapping machine has been improved greatly in
functions, performance and appearance after continuous tests and improvements by our R&D
team. It overperforms competitors' similar machine in quality. Theoretically, up to 700 strap beats
can be achieved for a battery charging, the maximum tension force can reach 2800N (the direct
tension force of strap tension wheel can reach 4200N), and the welding time is as short as 1s.
Working modes: Fully Automatic (AUT), Semi-Automatic (SEM), Manual (MAN).
To Next Page
Loading...