What to do if DMS Q31 Packaging equipment is short of power?
If your DMS Packaging equipment is experiencing a power shortage, check the battery power. If the battery is low, charge it fully before attempting to use the equipment again.
What to do if DMS Packaging equipment strap broken after operation?
If the strap breaks after the operation is completed on your DMS Packaging equipment, check whether the cooling time is too short.
How to fix incomplete welding in DMS Packaging equipment?
Incomplete welding in your DMS Packaging equipment may be due to a worn friction toothed plate. Consider replacing the friction toothed plate to resolve this issue.
Why does DMS Q31 slide forward when tensioning strap?
If your DMS Packaging equipment slides forward when tensioning the strap, it's likely due to a worn anti-sliding toothed plate. Replacing the anti-sliding toothed plate should solve this problem.
How to retract strap in DMS Q31 Packaging equipment?
If the strap cannot be retracted or pulled in your DMS Packaging equipment, increasing the tension grade may resolve the issue.
What causes tension motor to idle in DMS Q31?
If the tension motor idles in your DMS Packaging equipment, it is likely that the tension wheel is worn. Replacing the tension wheel should rectify this issue.
What to do if the strap is too thin for DMS Q31?
If the strap is too thin for your DMS Packaging equipment, add an appropriate gasket under the anti-sliding toothed plate.
What to do if tension wheel cannot be lifted in DMS Q31?
If the tension wheel of your DMS Packaging equipment cannot be lifted and you're unable to remove the strap, check if it is stuck by residual strap. Also, verify if the strap retraction switch tool is faulty.
Stay alert, use common sense, and wear protective equipment when operating a power tool.
Use the correct tool, maintain it, and disconnect power before adjustments.
Protect environment, do not disassemble batteries, and recharge with specified chargers.
Use professional straps dispenser and fold the strap end into it after operation.
Unqualified welding joints must be cut off and re-operated to ensure secure strapping.
Service by qualified personnel, maintain tool, check parts, clean regularly, and charge battery every six months.
Introduction to the Q31 series battery-powered strapping machine, its improvements, and capabilities.
Specifications for the machine's length, width, height, and weight.
Details on strap material, width, and thickness for the strapping machine.
Information on tension force range, tightening speed, and welding strength.
Parameters and specifications for purchasing a replacement lithium battery.
Details on input voltage, output voltage, and charging time for the standard chargers.
Information regarding the included free tool kit.
Instructions for installing the battery, including charging and handling precautions.
Details on unlocking/locking the operation panel and waking the machine from sleep mode.
Detailed explanation of the operation panel layout and button functions.
Explanation of mode selection, tension force setting, and welding time setting.
Detailed operation methods for Manual, Semi-Automatic, and Fully Automatic modes.
Key operational points for installing battery, strapping, and idle states for different modes.
Visual inspection criteria for determining if the strap welding time and effect are appropriate.
Guidance on adjusting parameters for optimal strapping effect, especially for tension and welding time.
Table providing reference values for tension force based on gear selection in different modes.
List and explanation of error codes displayed by the machine for fault diagnosis.
Guidance on diagnosing and resolving common operational issues and malfunctions.
General| Brand | DMS |
|---|---|
| Model | Q31 |
| Category | Packaging equipment |
| Language | English |
To Next Page