DMS Q31 - Basic Settings

Rocker lever/Handle:
Holding up the rocker lever, you can lift
the tension wheel; retract the strap or stop
the machine in an emergency.
5.2.2 Basic Settings
Mode
selection(MODE)
After the operation
panel unlocked, you
can cycle to select a
mode you need by
short pressing the
button MODE.
Manual mode (MAN): Tensioning function and welding
function will be operated separately. Press and hold the button
Tensioning A until the set tension force is reached and then
press the button Welding B for manual strap welding & cutting
.
Semi automatic mode (SEM): Long press the button
Tensioning A, and the straps will be tensioned and welded one
time.(The tension wheel will stop rotating if the button
Tensioning A is released during the tensioning process, and at
this time, the tool will start welding and cutting off the strap if
the button Welding B is pressed.)
Fully automatic mode (AUT): Short press the button
Tensioning A, and the machine will automatically tension, weld
and cut off the strap. Under this mode: The strap will be
tensioned automatically, and will be welded and cut off
automatically when the tension grade re
aches the set one.
Tension force
setting(SET)
After the operation
panel unlocked:
 Adjust the strap
tension range
(Grade 1-9) by
short pressing the
button SET. The
larger the number
is, the stronger the
tension force will
be; and the weaker
on the contrary.
(Grade 1 stands
for the minimum
tension force, and
Grade 9 for the
maximum.)
 The default
factory setting of
the machine is
Normal Mode H.
Long press the
Normal Mode (H- -):
Tension force range: 400-2800N (adjustable, the tension force
of the tension wheel can reach 4200N.)
Grade: 1-9
Instruction: This mode is used when objects to be strapped are
required to be strapped relatively tightly (or when a PET strap is
used).
Note: in the Normal Mode, please adjust the tension force
for your desired one by increasing the tension force from the
minimum in sequence; and avoid the maximum grade, as
the tension force at this grade is the strongest, a strap can't
bear it, which will cause personal injuries of the operator.
Soft Mode (L- -):
Tension range: 400N-1600N