DNP CX210 - Page 42

42
TR Overheat
TR Broken
TR Sensor Broken
RR Overheat
RR Broken
RR Sensor Broken
RR Overheat
RR Broken
RR Sensor Broken
Overcool
Head Overheart
EEPROM Broken
MG Unconnected
MG Mechanical
MG Hardware
**
MG Write
Hardware
**
MG Encode
**
Error code Description of error Remedy
Retransfer roller overheating Turn the power off and then on again. Call for service if the
problem persists.
Troubleshooting (continued)
Should your printer require servicing, turn it off and unplug it and make inquiries at the
outlet where it was purchased.
Retransfer roller malfunction Turn the power off and then on again. Call for service if the
problem persists.
Retransfer roller thermister
malfunction
Turn the power off and then on again. Call for service if the
problem persists.
Bend remedy roller overheating
error
Turn the power off and then on again. Call for service if the
problem persists.
Bend remedy roller malfunction Turn the power off and then on again. Call for service if the
problem persists.
Bend remedy roller thermister
malfunction
Turn the power off and then on again. Call for service if the
problem persists.
Bend remedy roller overheating
error
Turn the power off and then on again. Call for service if the
problem persists.
Bend remedy roller malfunction Turn the power off and then on again. Call for service if the
problem persists.
Bend remedy roller thermister
malfunction
Turn the power off and then on again. Call for service if the
problem persists.
Overcool The usage environment temperature is too low.
Use at the specified usage environment temperature.
(Call for service if the problem persists.)
Thermal head overheated Turn the power off and leave the unit for about 10 minutes before
switching on again. (Call for service if the problem persists.)
EEPROM malfunction Turn the power off and then on again. Call for service if the
problem persists.
MG connection error Turn the power off and then on again. Call for service if the
problem persists.
MG mechanical error Turn the power off and then on again. Call for service if the
problem persists.
MG hardware error Turn the power off and then on again. Call for service if the
problem persists.
MG writing error Check the type and direction of the magnetic cards and press
the “reset → enter buttons”. Call for service if the problem persists.
Hardware error Turn the power off and then on again. Call for service if the
problem persists.
MG encode error Check the direction of the magnetic cards.
Press the “reset →
enter buttons”
and call for service if the problem persists.