User Information Ringlock Ringlock Quality Factors & Designation
999817902 - 11/2020
5
Ringlock Quality Factors & Designation
Ringlock Quality Factors
All of Doka Euro range of Ringlock products are en-
gineered to meet the highest quality standards based
on three simple factors:
Material We only use the highest quality steel in
ourproducts.Oursteeliscertiedand
tested,itconformstoorexceedsindus-
try standards no matter the location or
climate.
Fit Doka products are engineered with
versatilityandusabilityinmind.Our
modiedproductdesignsincreaseef-
cienciesandproductivity,savingyour
projects time and money.
Finish Whereapplicable,ourproductsaren-
ished and protected by hot-dipped zinc
galvanizing.Thismethodofnishing
maximizestheutilizationandextends
the product life.
For additional information on Ringlock system compo-
nents please consult your local Doka representative.
Designation of Ringlock
The Designation of Ringlock in accordance with BS
EN 12810-1:2003 is:
ScaoldEN12810–4D–SW109/307–H1–B–LS
ServiceLoadClass4maybeextendedfromService
Load Class 1 to Service Load Class 6 if required al-
though there are restriction on bay length for Service
Load Classes 5 and 6. This User Information only con-
siders Service Load Class 1 to Class 4 as the general
loadingrequiredofasystemscaoldundernormal
circumstances.
Service Load Class 4: The following combinations of
platform width and bay length are also available:
SW06/73toSW12/307
CLADDING: Maximumpermissibleheightsandtie
patternsaregivenforbothunsheeted,debrisnetted
andsheetedscaolds.
AlldesignationsforRinglockScaoldareontheRin-
glockSystemScaoldDesignationCerticateofCom-
pliance included at the rear of this Guide.
For more information on products not found within this
document or the Ringlock Brochure please consult your
localDokarepresentative,oronlineatwww.Doka.com.
To Next Page
Loading...
