Dometic SmartStart III - Procedures

25
AppendixIIInstallation&SetupProcedures 
TheLowEndChillercanbesuppliedasastandalonechilleroritcanbesuppliedaspartofastagedsystem.
Thefactorydefaultsettingissetasastandalonechill er.
Whensuppliedaspartofamodularsystemthefollowingconnectionsneedtobeconfigured.
o CW&SWconnectionsbetweeneachstage.
o Networkconnectionsbetweeneachstage.Physicalandnetworkaddressing.
o EnsuringFirmwareisidenticalbetweeneachstage.
o Remotecontrolpanelconfiguration.

Thisdocumentaimstocoveralloftheaboveandtorunthroughsettin gthetime,dateandunitofmeasurement.
Chillerssuppliedonaframepackagewillbeconfiguredandwiredaspartofthebuildprocess.
Pleasealsonotethataspartofacorrectlyconfiguredmultistagesystemthere
isnoneedtoset
differential/hysteresissettings.




