OPERATION
L025317 Issue 5 July 2014 3-23
Setup Aiming
Home > Settings > Global Print Settings > Setup Aiming
The aiming beam may be used for installation to see where the objects of
the message are located on the product to print on.
Three options are implemented:
• Aiming beam disabled
• Aiming beam with laser power at the same time
• Aiming beam without laser power (aiming beam only).
Content/Shift Codes
Home > Settings > Global Print Settings > Content
The Setup Shifts screen allows the start time of each shift and a shift code
to be set. Each shift continues until the start time of the next shift.
Click on +Add Row to add a new shift. Enter the start time and the shift
code. Delete a shift by using the delete button.
To Next Page
Loading...
