INSTALLATION INSTRUCTIONS
L025317 Issue 5 July 2014 2-15
Connecting Laser Head Cable to X11
The flange socket (X11) on the laser head is located on the front panel.
If the groove on the flange socket is not properly aligned, the cable should
be turned, not the plug.
Twists in the cable are to be avoided by properly routing the cable.
USB 1.1 Port
The USB 1.1 ports are located on the top right hand side of the front of the
control unit.
Ethernet connections
There are two Ethernet connections. Ethernet 1 connection is
pre-configured for access via the IP address 192.168.58.2 / subnet mask
255.255.255.0. The connector is a RJ45 Bulgin connector.
Ethernet 2 connection (X59) is pre-configured for plug and play connection
of the optional Touchpanel. The IP address is 192.168.57.2 / subnet mask
255.255.255.0.
To Next Page
Loading...
Need help?
General
