OPERATION
3-56 L025317 Issue 5 July 2014
PRINTER NETWORK
Home > Settings > Printer Network
CAUTION: Setup for trained users and service technicians only.
The system may be damaged by incorrect settings.
All warranty is lost when the system is damaged by
incorrect settings.
Ethernet
Home > Settings > Printer Network > Ethernet
Setup of the Ethernet connection to the printer.
Multi-Head
Home > Settings > Printer Network > Multi-Head
Setup of the optional Multi-Head functionality. A reboot is required after
selecting this feature.
The Multi-Head option allows operating several controllers and lasers using
just a single interface, both for connected machines and for the operator.
The controllers are connected to a chain and all communication and
operation is done via the master controller of this chain.
One can configure multiple systems to not print synchronously. One can
then still use a common TouchPanel and a common interlock circuit but use
separate trigger signals for each laser. This is useful if you have multiple
parallel but independent production lines with one housing for multiple
lasers.
Serial
Home > Settings > Printer Network > Serial
Setup of the optional serial RS232 interface of the printer.
Advanced
Home > Settings > Printer Network > Advanced
Setup of the Dynamark interface which may be used to send commands
directly to the printer.
To Next Page
Loading...
Need help?
General
