MAINTENANCE AND FAULT FINDING
5-4 L025317 Issue 5 July 2014
(3) Inspect the cotton swab. If dirt or oil is present, repeat steps (1) to (3).
(4) Use the dry end of the cotton swab to lightly wipe excess liquid from
the lens.
GENERAL CLEANING
The outer surfaces may be cleaned with a damp cloth and a mild cleaning
agent only. No humidity must get into the system.
FAULT FINDING
It can be assumed that the D-Series laser systems should require no
service when properly operated. However, should there ever be a fault,
service employees of Domino are at your service. For service assistance
please visit the following website http://www.domino-printing.com and use
the Global Map to search for local technical support.
WARNING: The laser marking system and the
connected installation must be switched
off with the mains supply to the laser
marking system disconnected.
To Next Page
Loading...
