67
Inspection and repair
Make the necessary adjustments, repairs and part
replacements if excessive wear or damage is found
through inspection.
Bearing replacement
Removal ;
Use a bench press
Assembly
Use a bench press to install two bearings with a
marked side outward.
Reassembly
To assemble, follow the disassembly procedures in
reverse order.
Important operation
¡¡
‹
Shaft, bearing and spacer (5)
Lubricate the bearing with multi-purpose grease.
¡¡
‹
Washer, seal and seal unit (6)
Apply a thin coat of liquid gasket(Belco bond No. 4) to
the seal unit outer periphery before installation.
Marked side outward
Marked side outward
Lubricate with multi purpose grease
Apply liquid gasket
To Next Page
Loading...
