OP000509
4-1
Inspection, Maintenance and Adjustment
OP000509
4Inspection, Maintenance
and Adjustment
BASIC PREVENTIVE
MAINTENANCE
For the machine to function satisfactorily and at lowest
possible cost, a thorough maintenance program is required.
This section of the manual describes the maintenance work
which the operator can carry out. If certain operations
require trained workshop personnel and special equipment,
this will be indicated.
The intervals recommended between checks, oil changes
and lubrication apply provided that the machine is used
under normal environmental and operating conditions. See
“Lubrication and Service Chart” on page 4-17
Arrival and Delivery Inspection
Before the machine leaves the factory, it is tested and
adjusted. The dealer must also, if the warranty is to apply,
carry out "Arrival and Delivery Inspections" according to
applicable form, which must be signed.
Delivery Instructions
When handing the machine over, the dealer must give the
buyer "Delivery Instructions" according to applicable form,
which must be signed, if the warranty is to apply.
Figure 1
To Next Page
