OP000509
4-17
Inspection, Maintenance and Adjustment
LUBRICATION AND SERVICE
CHART
Greasing Bearing
The service life of bushings and pivot pins can be extended
considerably, if the machine is greased regularly and in the
correct way.
The greasing of bearings has two main purposes:
• Add grease to the bearing to reduce friction
between pin and bushing.
• Replace old grease which may contain dirt. The
grease in the space inside the outer seal collects
dirt and prevents dirt and also water from
penetrating into the bearing.
Therefore, grease the bearing until new, clean grease is
forced out through the outer seal.
Between 10 and 15 strokes with a normal handheld grease
gun is required to grease one of the bearings for the lifting
arms.
Wipe off grease fittings and grease gun before greasing, so
that dirt and sand is not introduced through the grease
fittings.
Symbol key
These standard symbols are used in “Lubrication and
Service Chart” on page 4-18.
Symbol Description Symbol Description
Lubrication Air Cleaner Element
Transmission Oil Fuel Filter
Engine Oil Air Conditioner Filter
Engine Oil Filter Drain Water
Hydraulic Oil Gear Oil (Axle)
Hydraulic Oil Return Filter Brake Filter
Coolant Level Check
To Next Page
