OP000506Safety
1-4
GENERAL SAFETY
ESSENTIALS
Accessory Applications
The wheel loader has been designed primarily for moving
earth with a bucket. For use as a grapple or for other object
handling, contact DOOSAN. Lifting-work applications are
permitted in approved lift configuration, to rated capacity
only, with no side-loading (unless prohibited by local
regulation). Do not use machine for activities for which it
was not intended. Do not use bucket for lifting work, unless
lift slings are used in approved configuration.
LOCATION OF SAFETY
LABELS
The operator should know and pay attention to the
information and warning plates/decals which are positioned
on the machine.
There are several specific warning signs on this machine.
The exact location of hazards and the description of the
hazards are reviewed in this section.
Please become familiarized with all warning signs.
Make sure that all of the warning signs are legible. Clean
the warning signs or replace the warning signs if you cannot
read the words. Replace the illustrations if the illustrations
are not visible. When you clean the warning signs, use a
cloth, water and soap. Do not use solvent, gasoline, or other
harsh chemicals to clean the safety signs. Solvents,
gasoline, or other harsh chemicals could loosen the
adhesive that secures the warning sign. Loose adhesive will
allow the warning sign to fall off.
Replace any safety sign that is damaged, or missing. If a
safety sign is attached to a part that is replaced, install a
safety sign on the replacement part.
To Next Page
