OP000506Safety
1-20
Any reinforcement system that is installed on machine must
pass safety and certification standards and carry appropriate
labeling and rating information. For example, most often
added type of reinforcement system, FOPS, must meet or
exceed Society of Automotive Engineers standard SAE
J1356, "Performance Criteria for Falling Object Guards for
Wheel loaders."
Never attempt to alter or modify any type of protective
structure reinforcement system, by drilling holes, welding,
remounting or relocating fasteners. Any serious impact or
damage to the system requires a complete integrity
reevaluation. Reinstallation, recertification and/or replacement
of the system may be necessary.
Install Additional Safety Equipment If
Conditions Require
Laminate glass protection for the front, side or rear windows,
along with tempered glass, may also be recommended
depending upon particular site conditions.
Contact your DOOSAN distributor for available safety guards
and/or recommendations if there is any danger of getting hit
by objects that could strike the operator's cabin. Make sure
that all other work site crew members are kept well away
from wheel loader and safe from potential hazards.
Maintain Standard Safety Equipment in
Good Condition
Machinery guards and body panel covers must be in place
at all times. Keep well clear of rotating parts. Pinch point
hazards such as cooling fan and alternator drive belts could
catch hair, jewelry or oversize or very loose clothing.
Safety labels must be replaced if they are damaged or
become unreadable. Information on labels gives work crew
members an important safety reminder. Part numbers for
each decal and required mounting locations are shown on
pages 1-2 through 1-4 of this section.
Attachment Precautions
Option kits are available through your dealer. Contact
DOOSAN for information on available one-way (single-acting)
and two-way (double-acting) piping / valving / auxiliary
control kits. Because DOOSAN cannot anticipate, identify or
test all of the attachments that owners may wish to install
on their machines, please contact DOOSAN for authorization
and approval of attachments, and their compatibility with
options kits.
HAOA100L
Figure 11
To Next Page
Loading...
