DV11
Operation and Maintenance
108
Engine Reassembly
Printed in Mar. 2005 PS-MMA0608-E1A
Torque 4.4 kg.m
3.3.29. Starter
z Install stud bolts at the bolt holes
on the flywheel housing for
installing the starter.
z Insert the starter into the flywheel
housing and tighten the fixing nuts.
Torque 8.0 kg.m
3.3.30. Air compressor
z Assemble the piston assembly into
air compressor cylinder liner before
installing it to the flywheel housing.
(Same method as that of piston
reassembly)
z Fit a gasket to the air compressor
fitting surface of the flywheel
housing.
z Assemble the connecting rod of the
air compressor liner assembly with
the air compressor crankshaft and
tighten it to the specified torque.
z Tighten the air compressor liner
with the fixing bolts.
z Tighten the air compressor liner of
side positioned with the fixing bolt
by special tool. (“T” type socket
spanner)
z Mount gasket on the air
compressor liner.
z Tighten the air compressor head
fixing bolts to the specified torque.
To Next Page
Loading...
