DV11
Operation and Maintenance
194
Maintenance of Major Components
Printed in Mar. 2005 PS-MMA0608-E1A
(1) Lubricating system
z Before reassembling the turbocharger onto the engine, inject new oil in the
oil inlet port and lubricate the journal and thrust bearings by rotating them
with hand.
z Clean not only the pipes installed between the engine and oil inlet port but
also the oil outlet pipe and check them for damage or foreign matters.
z Assemble each joint on oil pipes securely to prevent oil leaks.
(2) Air intake system
z Check the inside of the intake system for foreign matters.
z Assemble each joint on the intake duct and air cleaner securely to prevent
air leaks.
(3) Exhaust system
z Check the inside of the exhaust system for foreign matters.
z Be sure to use heat resisting steel bolts and nuts. Do not interchange them
with ordinary steel bolts and nuts when performing reassembly operation.
Apply anti-seizure coating to the bolts and nuts.
z Assemble each joint on the exhaust pipes securely to prevent gas leaks.
To Next Page
Loading...
