DORMA CS 80 MAGNEO
11
max. 2200 mm
01462 477 602
GB
Please call the following number in case
of technical problems or further questions:
5. Before mounting
Basic requirements:
Work on electrical equipment may only be performed by properly qualified staff
(electricians).
When the system is installed with permanent power supply (the cable comes directly out
of the wall), ensure that the power supply line is dead (de-energized) during installation.
The power supply line, max. 3 x 1.5 (Schuko-type shockproof socket or permanent
power supply) must have a 10 A fuse protection.
Opening direction:
Please note:
·
·
·
·
The floor has to be level.
Glass door panels have to be made of safety glass.
The connection cables for external accessories (program switch etc.) must be located in
the close range of the operator before starting the installation of the system.
With in-wall mounting, the wall must not be closed before the system has been mounted.
The connections of the operator are always located on the side where the door is when it
is in closed position.
Therefore the operator is symmetrical and can be turned the way you require it.
This installation instructions show the system with connection on the right side.
Thus the installation with connection on the left side is realised laterally reversed.
In case you require additional accessories, please contact your local dealer.
If you have technical questions or require help during the installation of the system, please
contact our hotline under the following number:
mm
2
The cable of the power supply line has a
length of 2.5 m. Thus a Schuko-type
shockproof socket (230 V AC, 50/60 Hz)
must be available within this distance.
When installing the socket, please
remember that you should be able to
reach it by hand.
For in-wall mounting:
To Next Page
Loading...
Need help?
General
