DORMA CS 80 MAGNEO
35
13. Commisssioning and maintenance according to DIN 18650-2, 5.1-5.4
According to DIN 18650, the following points have to be observed:
An inspection and acceptance test according to the below-mentioned checklist has to be
performed before the first commissioning of the system by trained staff (trained by
DORMA).
Regular maintenance and inspections have to be performed (at least once a year) under
consideration of our specifications for the CS 80 MAGNEO by properly trained staff.
Documentation of the results in accordance with DIN 18650-2 paragraph 5.1-5.4.
The facility operator has to keep the properly filled-out checklist according to our
specifications for at least 1 year.
The system has been installed properly in accordance with the instructions of the
manufacturer.
The door panels run smoothly/have been readjusted (if required).
The door works properly (check the opening and closing cycle respectively).
Function of installed activators like radar motion detectors, pushbuttons or remote
controls has been checked.
The contactless safety equipment (safety sensors), if installed, has been checked for
proper function.
Effective safety equipment has been installed to avoid or protect danger spots between
certain parts of the door system and between the door and its structural environment (like
for example safety clearances or the protection of the secondary closing edges).
Test badge has been fixed.
The inspection and maintenance work has been documented.
The has to be switched off and secured against unintended and unauthorized
switching on before performing maintenance work (cleaning or maintenance).
Only use commercial cleaning agents to clean the operator.
Scrubbing cleansers might damage (scratch) the surface of the operator
·
·
·
Checklist (start-up test, maintenance, regular inspections) according to DIN 18650-2,
paragraph 5.1-5.4
CS 80 MAGNEO
Care
.
To Next Page
Loading...
Need help?
General
