Dorma CS 80 MAGNEO Technical Documentation

DORMA CS 80 MAGNEO
36
11. Troubleshooting instructions
Malfunction
The door does not
respond.
The green LED light
indicator is off.
The door does not
respond.
The green LED light
indicator is on.
The green LED light
indicator blinks at
certain intervals.
The door stops during
a cycle.
The door moves
beyond the adjusted
open or closed
position.
The red LED light
indicator illuminates
permanently.
The red LED light
indicator blinks twice
at certain intervals.
The red LED blinks 3
times at regular
intervals.
Possible cause
No power supply.
Loose cable connections.
Damaged power cord.
Damaged power plug.
The program switch is set to
(OFF).
The program switch is set to
(Permanent Open).
The door has been adjusted to
Permanent Open Function via
double-click.
The safety sensors at the door
are activated (there is something
within the detection range of the
sensor).
Damaged sensor cable.
No safety sensors are connected.
The operator is defective.
The learning cycle has not been
performed properly.
The door does not run smoothly.
The corresponding end stop has
shifted its position.
Defective control unit.
Defective control unit.
The power mode switch of the
door has been switched to
another position.
The operator is defective.
[0]
[II]
Remedy
Switch on mains switch.
Connect cable connections
thoroughly.
Replace power cord.
Replace operator.
Set the program switch to the
desired function.
Set the program switch to the
desired function.
Close door via double-click.
Remove obstacles. Adjust safety
sensors if required.
Check and replace cables if
required.
Check and replace jumpers if
required.
Terminals must be bridged.
Replace operator.
Restart learning cycle (Page 31).
Check movement range and
remove cause for unsmooth
running.
Check guide rail and floor guide
for dirt or wear and clean or
replace if required.
Readjust end stop and tighten
screws.
Switch mains switch off and on.
Replace operator.
Switch mains switch off and on.
Replace operator.
Switch mains switch off and on.
Replace operator.
Start learning cycle (Page 31).

Dorma CS 80 MAGNEO Specifications

General

Brand	Dorma
Model	CS 80 MAGNEO
Category	Door Opening System
Language	English