DORMA PORTEO
WN 057472 45532 02/08
General information
PORTEO door assistant
Settings/Adjustments
The has been pre-adjusted for various kinds of applications (basic
settings).
The settings: swing direction, door weight, door width, way of mounting, and
are important for the smooth and proper operation of the door system.
Some of these settings are part of the basic settings, others have to be determined while some
settings are determined automatically during the learning cycle.
The determination of the settings is a simple and plain procedure that is described on the
pages 14 to 19.
The opening or closing cycle is triggered either by active or automatic activators.
The activator sends a signal to the control unit.
The control unit in turn sends the pulse to the motor.
The motor starts and converts the pulse into a movement.
The arm transfers the movement of the motor onto the door.
The door performs either an opening or a closing cycle.
There are either active or automatic activators.
Active activators are for example pushbuttons or door handles while automatic activators are
radar motion detectors or sensors.
- swing direction -left or right
- way of mounting -lintel mounting or door leaf mounting
- mounting side -hinge side/pull side or opposite hinge side/push side
- lintel depth (see page 10)
- kind of accessory -slide channel (standard) or projecting arm
- door width
- door weight
- position of the door when closed (”closed” position)
- position of the door when it is completely open (”open” position, freely adjustable)
- and latching action.
Each setting is learnt automatically during commissioning.
Follow the instructions indicated in the commissioning instructions.
- see page 14 and 15.
- see page 16 to 19.
"closed" position
"open" position
Function
The control unit of the PORTEO door assistant requires the following parameter settings for
control-internal operations:
Standard commissioning
Extended commissioning
Function and adjustments
GB 11
To Next Page
Loading...
