DORMA PORTEO
WN 057472 45532 02/08
General safety instructions
Risk assessment on the part of the installer
“risk assessment” form
internet homepage “www.dorma.com/porteo”
Special requirements regarding the protection of people in need of protection
Limitation of liability
PORTEO door assistant
Required preparation on site
PORTEO door assistant
Following installation
Due to special spatial conditions and the expected user group of the door, the application of
safety sensors could be reasonable also for a low-energy operator
Thus an individual risk assessment has to be performed during planning by the
manufacturer, i.e. by the person performing the installation of the doors system
For this purpose we would ask you to refer to our , which is available on
our and will help you to perform the risk
assessment
In case the risk assessment reveals that there is a health risk or risk of injury caused by the
door hitting a person using the door with an unacceptable force, an additional protection by a
safety device (connection of a safety sensor) is required.
This is especially necessary when people in need of protection (children, elderly people or
disabled people) use the door.
The must only be applied according to its intended application.
The DORMA GmbH + Co. KG does not accept any liability for damages resulting from
unauthorised modifications of the system.
Important instructions for the safe installation of the system.
All instructions mentioned in the documentation have to be observed.
An incorrectly performed installation might entail serious injuries.
To insure the proper safety of people, it is important to abide by these instructions.
These instructions have to be kept.
The working area has to be secured against unauthorised access from other people.
Falling items or tools might cause injuries.
In any case, the way of installation and the mounting equipment, like screws and wall plugs,
have to be adequate with regard to the structural conditions (steel structure, wood, concrete,
etc.). Before the installation of the , the door leaf/door leaves has/have
to be checked with respect to proper mechanical condition and smooth running.
Following installation, the setting and the proper function of the operator and the safety devices
have to be checked.
The installation instructions of this operator are only an example. Structural or local conditions,
available tools or other conditions might suggest a different approach.
4.
5. Documentation
6. General information regarding the installation
.
.
.
When performing mounting and installation work: The has to be de-
energized before removing the cover. Remove power plug, or, in case of permanent power
connection, switch off fuse.
ü
PORTEO door assistant
GB 06
To Next Page
Loading...
